How to maintain the incubator？

Due to the seasonal use of the incubator and its own work limitations, there may be idle times. At this stage, attention must be paid to the maintenance of the incubator. So that it can be put into operation smoothly when it is used again. Today we will share with you: the maintenance details of the incubator when it is idle.

A friend parked the incubator in the open air when it was idle. Due to poor storage, the incubator was rusted and rotted by wind, rain, and sunlight, and the degree of deformation and damage was more serious than when it was used, which not only caused great losses, but also had potential safety hazards. . Therefore, the incubator must be well maintained when it is idle. The specific maintenance methods are as follows:

1. It is best to place the incubator in the shed. The field should be flat, dry and easy to drain. The field should have a certain hardness and slope, and be equipped with fire extinguishers or fire prevention equipment. If the hatcher is parked on dry brick, its rust rate will be approximately half lower than on dirt.

2. In order to prevent sun exposure and exposure, cover the hatcher. When possible, apply a layer of paraffin oil to minimize exposure to sunlight and air. The incubator should be off the surface and not in contact with the soil.

3. The parking place of the incubator should pay attention to moisture-proof.

4. In order to prevent the deformation of the parts of the incubator, the stress state of the parts should be removed as much as possible to minimize the deformation. So that its working performance is not affected, for the parts that are prone to deformation, methods such as padding and hanging should be adopted to reduce the deformation factors.

5. The moving parts of the incubator should be fully lubricated and rotated regularly to prevent rust. The surface of the metal working parts of the incubator must be painted or coated with anti-rust oil to prevent rust.

6. Regularly check the incubators in storage, and solve problems in time. For long-term storage of the incubator, regularly check the dust removal, and rotate the moving parts regularly to prevent the moving parts from rusting.